Envision Peripherals NV3128 User Manual download pdf (Page 43)

NV3128 RS-422A Machine-Control Routing Switch 2-19

2.6 PC DIAGNOSTIC INTERFACE (UNIDIAG/NVUTILS)

NVision furnishes a configuration and diagnostic computer utility with

the routing switch. For newer systems having the Universal Control

Card, the program is called UniDiag. For older systems having the

Command Interpreter, the collection of programs is called NVUtils or

RouterDiag. The program(s) run on a PC compatible computer.

Connect the PC RS-232 serial port to the nine-pin D connector at the

front of the Control/Command Interface Module (preferred), or to the

RS-422/RS-232 Diag connector at the back of the frame. For newer

systems, detailed information about this interconnection and the

diagnostic program can be found in the UniDiag manual.

CABLING COMPLETE

You are now finished making cable connections to the NV3128

Router. The remainder of this section explains how to install NVUtils

for use in configuring routers that have the old Command Interpreter

module. Newer routers with the Universal Control Card can skip the

remainder of this section and go to the UniDiag manual for configuration

information.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 91 92

No comments

Envision Peripherals NV3128 User Manual Page 43