Envision Peripherals G2219 User Manual

9 FRONT PANEL CONTROL • Power Button: Press this button to switch ON/OFF of monitor’s power. • Power Indicator: Green — Power On mode. Orange

10 HOW TO ADJUST A SETTING 1. Press the MENU-button to activate the OSD window (Figure 5). 2. Press < or > to navigate through the funct

11 ADJUSTING THE PICTURE The descriptions for function control LEDS Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Description Luminance

12 Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Description Image Setup Clock Adjust picture Clock to reduce Vertical-Line noise. Focus

13 Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Description Color Boost Full Enhance on or off Disable or Enable Full Enhance Mode Nature Sk

14 Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Description OSD Setup H.Position Adjust the verticalposition of OSD V.Position Adjust th

15 Plug & Play DDC2B Feature This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the monitor to i

16 TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cord

17 FOCUS adjusts the phase of the pixel clock signal. With a wrong phase adjustment the picture has horizontal disturbances in light picture. For FOC

18 ERROR MESSAGE & POSSIBLE SOLUTION NO SIGNAL 1. Check that the signal-cable is properly connected , If the connector is loose, tighten

1 TABLE OF CONTENTS FOR YOUR SAFETY -------------------------------------------------- 1 SAFETY PRECAUTIONS --

19 APPENDIX SPECIFICATIONS LCD Panel Driving system TFT Color LCD Viewable image size 558mm diagonal Pixel Pitch 0.282mm(H) × 0.282mm(V) Input

20 External Controls: Switch • Auto Adjust Button • -/Eco mode • DCR/+ • Input Select • Power Button • MENU Functions • Luminance • Image

21 FACTORY PRESET TIMING TABLE STANDARD RESOLUTION HORIZONTAL FREQUENCY VERTICAL FREQUENCY VGA 640x480 31.469kHz 60 Hz 640x480 37.861kHz 72 Hz

22 CONNECTOR PIN ASSIGNMENT 156101115 15 - Pin Color Display Signal Cable PIN NO. DESCRIPTION PIN NO. DESCRIPTION 1. Red 9. +5V 2. Green 10. D

23 ISO 14001 Certification ISO 14001 certification is the pattern of certification of the environmental management system, is the core standard of IS

2 Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency

3 PRECAUTIONS  Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 

4 SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. NOTES • Due to the nature of t

5 INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing the Swivel Bas

6 CONTROLS AND CONNECTORS SIGNAL CABLE Connecting the Signal Cable: Plug the Signal Cable one end to LCD monitor’s “DSUB-Input” socket, the other e

7 ADJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to

8 OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located on the