Envision-peripherals EN7600 User Manual

9FRONT PANEL CONTROL Power Button:Press this button to turn the monitor ON or OFF. Power Indicator:Blue — Power On mode.Orange — Off mode. MENU /

10HOW TO ADJUST A SETTING 1. Press the MENU-button to activate the OSD window.2. Pressor to navigate through the functions. Once the desired

11ADJUSTING THE PICTURE The descriptions for function control LEDSMain Menu ItemMain Menu IconSub Menu ItemSub Menu IconDescriptionContrast Contrast

12Main Menu ItemMain Menu IconSub Menu ItemSub Menu IconDescriptionYes N/A Auto Adjust the H/V Position, Focus and Clock of picture.Auto ConfigNo N/A

13PLUG AND PLAYPlug & Play DDC2B FeatureThis monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It all

14TECHNICAL SUPPORT (FAQ)Problem & Question Possible SolutionPower LED is not on *Check if the Power Switch is in the ON position*Power Cord shoul

15ERROR MESSAGE & POSSIBLE SOLUTIONCABLE NOT CONNECTED :1. Check that the signal-cable is properly connected , If the connector is loose, ti

16APPENDIXSPECIFICATIONSDriving system TFT Color LCDLCD Panel Size 43.2cm(17.0")Pixel pitch 0.264mm( H ) × 0.264mm( V )Video R,G,B Analog Interfa

17Switch  Auto Adjust Key Brightness Contrast Power Button MENUExternal Controls: Functions  Contrast Brightness Focus Clock H. Position V.

18Preset Display ModesSTANDARDRESOLUTIONHORIZONTALFREQUENCYVERTICALFREQUENCYDos-mode 720 x 400 31.47kHz 70.0Hz640 × 480 31.47kHz 60.0HzVGA640 × 480

1TABLE OF CONTENTSTABLE OF CONTENTS -----------------------------------------------1FOR YOUR SAFETY --------------------------------------------------

191 561011 1515 - Pin Color Display Signal CablePIN NO. DESCRIPTION PIN NO. DESCRIPTION1. Red 9. +5V2. Green 10. Detect Cable3. Blue 11. TXD4. RXD 1

2Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference.FCC Class B Radio Freq

3PRECAUTIONS Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet baseme

4SPECIAL NOTES ON LCD MONITORSThe following symptoms are normal with LCD monitor and do not indicate a problem.NOTES Due to the nature of the fluores

5INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing the Swivel BasePOWER CORDPower Source:1. Make su

6CONTROLS AND CONNECTORS VIDEO CABLEConnecting the D-Sub Cable: Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect the

7ADJUSTING THE VIEWING ANGLE For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s an

8OPERATING INSTRUCTIONSGENERAL INSTRUCTIONSPress the power button to turn the monitor on or off. The other control buttons are located