Envision-peripherals EN-8500 User Manual

EN-8500 EN-8500 18” LCD Monitor With TV Tuner User’s Manual By Envision Peripherals, Inc. www.envisionmonitor.com Before

EN-8500 9 BASIC CONNECTIONS NOTE: 1. Connect the Power Adapter DC Cord to the monitor’s 12VDC Input. 2. Connect one end of the D-Sub ca

EN-8500 10 Preparing To Install The Optional Wall Mount Arm (not supplied): This monitor can be attached to a wall mounting ar

EN-8500 11 3. Attaching The Optional Wall Mount Arm (not supplied): Follow these steps to finish installing the wall mounting arm: 1. Pla

EN-8500 12 Connecting Other Video & Audio Sources: Connecting the Video & Audio Cable: In addition to VGA & TV inputs, this moni

EN-8500 13 INSTALLATION INSTRUCTIONS • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’

EN-8500 14 Press the Power Switch to turn the monitor ON or OFF. The other control knobs are located at the front panel of the monitor. By cha

EN-8500 15 USER CONTROLS (cont) 7. MENU ALL Modes: Open OSD menu or select the highlighted FUNCTION when OSD menu is already active. 8. A

EN-8500 16 REMOTE CONTROL OPERATING INSTRUCTIONS (cont)

EN-8500 17 • Press the Menu key to call up the OSD. The OSD shown below is from PC Mode. The detailed adjustment instructions for each m

EN-8500 18 There are seven display modes that you can choose by V-SEL key. PC Mode : Display the video signal from the PC. PC+TV Mode (PIP m

EN-8500 1TABLE OF CONTENTS COVER ……………………………………………………………………… TABLE OF CONTENTS …………………………………………………... 1 FOR YOUR SAFETY ……………………………………………………… 2

EN-8500 19 PC SCREEN ADJUST Menus – Available in PC & PIP mode. Icon Menus and Sub-menus Function Descriptions BRIGHTNESS Adjust the

EN-8500 20 OSD ADJUST menu – Available in ALL modes Icon Menus and Sub-menus Function Descriptions H.POSITION Adjust the OSD H.POSITION V.PO

EN-8500 21TV SETUP menu – Available in TV mode Icon Menus and Sub-menus Function Descriptions CHANNEL ADD/DEL To add/delete the selected TV Cha

EN-8500 22 Plug & Play DDC1/2B Feature This monitor is equipped with VESA DDC1/2B(Display Data Channel) capabilities according to the VESA

EN-8500 23TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position

EN-8500 24 Screen image is not centered or sized properly. *Adjust pixel frequency (CLOCK) and FOCUS or press hot-key (AUTO) Picture has color def

EN-8500 25 CABLE NOT CONNECTED : 1. Check that the signal-cable is properly connected , If the connector is loose, tighten the connector’s

EN-8500 26 FOR FIRST TIME INSTALLATION : This is a Plug & Play LCD monitor. Turn off the PC then connect the cables. Power on the PC and

EN-8500 27APPENDIX SPECIFICATIONS Driving system TFT Color LCD LCD Panel Size (18”) Pixel pitch 0.3585mm( H )x 0.3585mm( V ) Vi

EN-8500 28 Switch • Standby Power button • Input Video Source selected button • Input Audio Source selected button • Menu button • Auto Adjus

EN-8500 2FOR YOUR SAFETY Before operating the monitor please read this manual thoroughly. This manual should be retained for future reference. FC

EN-8500 29 STANDARD RESOLUTION HORIZONTAL FREQUENCY VERTICAL FREQUENCY 720 × 400 31.47kHz 70Hz VGA 640 × 480 31.47kHz 60Hz 640 × 480 35

EN-8500 30 This Telecommunications Act of 1996 in USA requires that every television made, starting in 1998, must be equipped with the technol

EN-8500 31 4. Setting up MPAA rating Mode – Select MOVIE GUIDELINES from the V-Chip menu. － Use Up/Down/Left/Right arrow buttons to move around

EN-8500 3 z Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. z

EN-8500 4 NOTES The following symptoms are normal with LCD monitor and do not indicate a problem. • Due to the nature of thefluorescent li

EN-8500 5 S • Set your resolution to 1024 x 768 @ 60Hz refresh rate for optimum display quality. • The screen surface is very soft. Do not rub

EN-8500 6BEFORE YOU OPERATE THE MONITOR FEATURES • 18” TFT Color LCD Monitor with TV Tuner • Composite & S-Video Inputs • PIP (Picture-i

EN-8500 7 The product package should include the following items: 1. EN-8500 LCD Monitor with TV Tuner 2. Quick Start Guide 3. Remote Contr

EN-8500 8 INSTALLATION INSTRUCTIONS POWER CORD Power Source: 1. Make sure the power cord is the correct type that required in your area.